10,000 Mile Service Information
Regular 10,000 mile maintenance is crucial for keeping your Ford F-Series truck running optimally and extending its service life. This checklist covers essential maintenance procedures for all F-Series models including F-150, F-250, F-350, and Super Duty variants. Always refer to your specific model's owner's manual for any variations in maintenance requirements.
Essential Maintenance Procedures
Follow these structured procedures during the 10,000 mile service interval.
Oil & Filter Service
- Drain engine oil completely (engine at operating temperature)
- Replace oil filter with OEM-quality filter
- Fill with appropriate oil (5W-30 synthetic for most F-Series)
- Check for leaks after filling
- Reset oil life monitor/maintenance reminder
- Record service in maintenance log
- Dispose of used oil properly
Tire Rotation & Inspection
- Rotate tires according to pattern (specific to tire type)
- Inspect tread depth at multiple points
- Check for uneven wear patterns
- Inspect sidewalls for damage or bulges
- Adjust tire pressure to specifications
- Inspect and torque lug nuts to spec (100-150 ft-lbs)
- Check TPMS function if equipped
Brake System Service
- Inspect brake pad/shoe thickness (minimum 4mm)
- Check brake rotors/drums for scoring or damage
- Inspect brake lines and hoses for leaks or damage
- Test brake fluid condition with test strips
- Top off brake fluid if needed (DOT 3 or 4 as specified)
- Check parking brake adjustment and function
- Test brake pedal feel and stopping performance
Air & Cabin Filter Inspection
- Remove and inspect engine air filter
- Replace if dirty or at recommended interval
- Check air filter housing for debris
- Inspect cabin air filter condition
- Replace cabin filter if dirty or restricted
- Clean filter housing before reinstallation
- Verify proper sealing of filter covers
10,000 Mile Inspection Checklist
Perform these inspections as part of the 10,000 mile service.
Engine Systems
- Check and top off engine coolant level
- Inspect coolant condition and freeze protection
- Examine all drive belts for wear or cracks
- Check belt tensioner operation
- Inspect all hoses for leaks or deterioration
- Check for unusual engine noises or vibrations
- Inspect for oil or fluid leaks
- Test engine for proper idle and acceleration
Transmission & Transfer Case
- Check transmission fluid level and condition
- Inspect for transmission leaks
- Check transfer case fluid level (4WD models)
- Inspect for transfer case leaks
- Test shift quality through all gears
- Check 4WD operation (if equipped)
- Inspect transmission cooler lines
- Check transmission mount condition
Steering & Suspension
- Inspect power steering fluid level and condition
- Check for steering fluid leaks
- Examine steering linkage for wear or damage
- Inspect steering gear box operation
- Check all suspension components for wear
- Inspect shock absorbers for leaks or damage
- Check ball joints and control arm bushings
- Test steering response and wheel alignment
Fuel & Emissions Systems
- Check fuel system for leaks
- Inspect fuel filter (replace if scheduled)
- Check fuel cap seal condition
- Inspect evaporative emissions components
- Check exhaust system for leaks or damage
- Inspect exhaust hangers and heat shields
- Check for exhaust smoke or unusual odors
- Scan for diagnostic trouble codes
Drivetrain & Axles
- Check front and rear differential fluid levels
- Inspect for differential leaks
- Check driveshaft and U-joints for play
- Inspect CV joints and boots (if equipped)
- Check for unusual drivetrain noises
- Lubricate driveshaft slip yoke (if applicable)
- Inspect axle seals for leakage
- Check wheel bearings for excessive play
Electrical System
- Test battery condition and voltage
- Clean battery terminals if corroded
- Check alternator output voltage
- Inspect all exterior lights for function
- Test horn operation
- Check wiper and washer operation
- Inspect visible wiring for damage
- Test all power accessories
Cooling System
- Pressure test cooling system
- Inspect radiator and cap condition
- Check cooling fan operation
- Inspect water pump for leaks
- Check thermostat operation
- Inspect heater hoses and connections
- Test A/C system performance
- Check cabin heating performance
Safety & Miscellaneous
- Check all seat belts for proper function
- Test all interior warning lights
- Inspect all mirrors for proper adjustment
- Lubricate door hinges and latches
- Check spare tire pressure and condition
- Inspect truck bed and tailgate operation
- Check frame and undercarriage for damage
- Inspect all fluid levels final check
© 2025 Ford F-Series Maintenance Checklist (10,000 Mile Service) | Developed by FleetRabbit | Contact us at support@fleetrabbit.com for customized maintenance solutions.